5 Cylinder Radial
Thanks Lad's, I think I have found my way out of it ,so expect work to resume shortly, as soon as I recover from falling down the stairs.
Only a few bruises and a bit shook up so OK.

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
That's no good! A fall like that can change your life. I advise against it. :)
Reply
Thanks given by:
Sorry to hear that Brian, hope you are on your way to a full recovery.
Smiley-eatdrink004 
DaveH
 a child of the 60's and 50's and a bit of the 40's Smile
Reply
Thanks given by:
Stay safe Brian - a zimmer frame can be a future project build but only after this one is finished!
Hunting American dentists since 2015.
Reply
Thanks given by:
On the other hand this could be the power unit for a zimmer Rotfl Rotfl Rotfl
Brian Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
All OK now. I am back to what seems normal to me.
The head now has inserts fitted. and valve seats cut. work on this head will continue leaving the others untill I have it finished correctly. complete with the cam, the damaged head will be used to prove the set up's.

This is another of my awful video's I lost some of the captions on this one in the down load,  oh well keep trying.





Brian. Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Hi Brian,

I fixed the link for you, so it is displaying properly, but I do see that some of the captions are cut off on the bottom. Check your original video to make sure that didn't happen in the editing.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Hi Tom
Thanks for fixing the Video.
the captions where lost when i exported the video to the format for downloading to Youtube
I must be sizing the photos incorrectly and the automatic resizing chops of the bottom.
I am sure I will get the hang of it eventually.
Thanks again for the back up   Brian. Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
As the material  was square I decided  to machine the inside first while it was simple to hold it in the 4 jaw.
Next came the end plate, now looking at the bar I wondered if it was possible to turn the spigot on the end and part off the piece, Now the bar was 12 1/2" long and my lathe is a 12x7 but it went between the small 4 jaw and the centre just dandy.
Next the part was milled to size,  But as I had to raise the head to clear the rotary table and boring head I now had to lift my small vise to reach the cutter. 
Now the real work can begin.

Well we all have our funny day's don't we.

   

   

   

   

   
Onward & upward   Brian. Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
Very interesting build, thanks for posting subscribed. Over head cam radial ..... is there such a thing... very unique ?
Magazines have issues, everything else has problems

Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)