This is the dial holder that I made to fit the QCTP, makes holding the dial indicator on centre so much easier than grabbing a Magnetic base.
It was made from a scrap of material left over from making a set of bearing splitters, and a chunk of 1/2" keystock.
Here is is mounted in a QCTP holder, ready to drop onto the lathe, set for height and ready to go.
Walter
It was made from a scrap of material left over from making a set of bearing splitters, and a chunk of 1/2" keystock.
Here is is mounted in a QCTP holder, ready to drop onto the lathe, set for height and ready to go.
Walter
starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.
