+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machinery (http://www.metalworkingfun.com/forum-10.html)
+--- Forum: Lathes (http://www.metalworkingfun.com/forum-11.html)
+--- Thread: Dial gauge holder for a QCTP (/thread-259.html)
Dial gauge holder for a QCTP - starlight_tools - 04-10-2012
This is the dial holder that I made to fit the QCTP, makes holding the dial indicator on centre so much easier than grabbing a Magnetic base.
[attachment=750]
It was made from a scrap of material left over from making a set of bearing splitters, and a chunk of 1/2" keystock.
Here is is mounted in a QCTP holder, ready to drop onto the lathe, set for height and ready to go.
[attachment=751]
Walter
RE: Dial gauge holder for a QCTP - EdK - 04-10-2012
Great idea Walter. That one's going on my project list.
Ed