MetalworkingFun Forum › Machining › Projects v
Poor mans machine jacks

Thread Modes
Poor mans machine jacks
mfletch Offline
Sophmore
***
Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
The following 8 users Like mfletch's post:
f350ca (01-24-2015), Highpower (01-24-2015), EdK (01-24-2015), stevec (01-24-2015), DaveH (01-24-2015), vtsteam (01-24-2015), arvidj (01-25-2015), confederatemule (03-04-2015)
#1
01-24-2015, 02:05 PM
Hi all made these simple and cheap machine jacks from old half inch drive sockets

[Image: P1020006_zpsufovdpsp.jpg]
mfletch, Try to do the best you can and that's good enough
Reply
Thanks given by: Shawn
krv3000 Offline
Senior
*****
Posts: 1,520
Threads: 157
Joined: Feb 2012
Location: uk
The following 1 user Likes krv3000's post:
confederatemule (03-04-2015)
#2
01-24-2015, 05:29 PM
hi thems spot on they do the job Smiley-eatdrink004
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
The following 1 user Likes doubleboost's post:
confederatemule (03-04-2015)
#3
01-24-2015, 05:30 PM
Nice welds
Good idea
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
confederatemule (03-04-2015)
#4
01-24-2015, 07:20 PM
Poor man, rich man - it doesn't matter as long as it does the job. Nice work.
Hunting American dentists since 2015.
Reply
Thanks given by:
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 2 users Like PixMan's post:
mfletch (01-25-2015), confederatemule (03-04-2015)
#5
01-24-2015, 11:27 PM
Nice. Now make them even better by facing the tops and milling a V-groove in the top (of at least one of them) for supporting rounds.
Reply
Thanks given by: mfletch
mfletch Offline
Sophmore
***
Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
The following 1 user Likes mfletch's post:
confederatemule (03-04-2015)
#6
01-25-2015, 05:25 AM
(01-24-2015, 11:27 PM)PixMan Wrote: Nice. Now make them even better by facing the tops and milling a V-groove in the top (of at least one of them) for supporting rounds.

Thank guys I will groove three more bolts
mfletch, Try to do the best you can and that's good enough
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)