12-13-2016, 07:39 PM
Will do Tom. Thanks for the tip.
Ed
Ed
|
Project Clamp Knurling Tool
|
01-08-2017, 06:28 PM
I tackled the slot today which has a couple of tight tolerance dimensions. I'm happy to say I didn't screw it up.
 Ed 
01-08-2017, 06:43 PM
That's always a good feeling!
Mike
SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949) Thanks given by: EdK
01-10-2017, 05:50 PM
Got the holes drilled and counter-bored. I even got the counter-bores on the correct side of the part.
 Next is to get rid of those corners and cut some angles. Ed
01-14-2017, 03:58 PM
Sweet success at last.
 Ed 
01-14-2017, 04:21 PM
(This post was last modified: 01-14-2017, 04:22 PM by Old Minger.)
May I be the first to congratulate you, awesome job!
 John Thanks given by: EdK
01-14-2017, 04:32 PM
Looks great Ed!
 I can't tell from the pic, but be sure the knurls are slightly chamfered before trying it out. Otherwise, they may dig into the work. Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) Thanks given by: EdK
01-14-2017, 05:00 PM
(01-14-2017, 04:32 PM)TomG Wrote: ... Now that I think of it, those knurls are not chamfered and are actually meant for my cut knurling tool project I may tackle some day. I might have grabbed the wrong knurls Anyway, what TPI knurls do you use the most? The ones I've got on the tool are pretty fine so, since I'm doing a McMaster order, I think I'll get some properly chamfered knurls. Ed EDIT: those knurls were not meant for my cut knurling tool project. I got them from McMaster for this project. Now I'm wondering about a source for the beveled edge knurls. They seem to be as scarce as hen's teeth. |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 3 Guest(s)