MetalworkingFun Forum › Machining › Projects v
First attempt at a knife

Thread Modes
First attempt at a knife
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
The following 2 users Like Shawn's post:
EdK (08-29-2014), f350ca (08-29-2014)
#1
08-29-2014, 07:11 PM
I still need too clean it up a bit but it was a fun afternoon project and I can see making a few more once I get some proper stock. The blade is a broken power hacksaw blade with an old deer horn I had for the handle.

[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
Hawkeye Offline
Junior
****
Posts: 536
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#2
08-29-2014, 09:48 PM
Cool. Could you outline your hardening and tempering routine, please? It would help any thinking of trying the same thing.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#3
08-30-2014, 01:03 AM (This post was last modified: 08-30-2014, 01:05 AM by Shawn.)
I didn't bother to anneal the hacksaw blade first. I was careful to not overheat it while grinding the profile and I used a dremell tool to grind out the two holes for the handle. I just checked the edge and a file still skates over the steel so my grind didn't get to hot. It was a fun project though and I'll be ordering some O1 plate to have another go.

[Image: image.jpg]

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)