Coke Forge Build

[f350ca]

The 36 grit isn't used over here, if we're going to do work that rough we just drag the part down a gravel road behind truck.

[krv3000]

rob you gowing to jhons on sat

[RobWilson]

(11-20-2014, 04:31 PM)krv3000 Wrote: rob you gowing to jhons on sat

Aye ,more than likely mate , you need out ?  



Rob

[EdK]

The 36 grit must have that same toxic substance the China suppliers used in the dry wall they sent over a few years ago that was making people sick. We don't allow that stuff here anymore. Good luck with that.

Ed

[Mayhem]

Hi Rob - could I suggest that you start a different thread for the linisher build?

[krv3000]

yep just fill the van up blue role and spray

[RobWilson]

Made a start on the butterfly valve , First off I slapped a 1" x 4" slice of EN3876 steel into the CUB Lathe for a wee bit of spinning about .



Next off two flats milled on the Viceroy mill .




Then onto the Aciera F3 to do the slots . Using a surface gauge to clock the job in , as I already had the PCD set .





Then onto the drill to have a couple of holes poked in , 




Body done .




Rob 

[awemawson]

Looking very nice Rob !

Not come across EN3876 before - is that a stainless steel?

[DaveH]

Rob,
Very nicely done - excellent job   Liked the set up to drill and ream the hole(s)

Well photographed
 
DaveH

[EdK]

As usual, very nice Rob.

Ed