Coke Forge Build
Looking smart Rob Drool  will it need balancing in any way ? or just run ok without it ?
  Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
I just read through this entire post, not sure how I missed this one? That's some really nice work, the welding looks amazing.

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
Nice work as usual Rob.

(09-23-2014, 05:39 PM)Micktoon Wrote: ...will it need balancing in any way ?...

Just stuff a hamster in it and see if it runs true Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
Thanks Lads  Smiley-eatdrink004


Mick it will be fine as is ,,,,,,,,,,,,,,,,,I hope  Big Grin ,  


And tonight's efforts , machined up four stand-offs that are used to mount the fan case to the motor , these were zapped onto the motor mount plate.

[Image: P1080388_zpsbdb589ef.jpg]  


All the parts ready for assembly .

[Image: P1080389_zps4184a53e.jpg]



First up the fan case mount is bolted to  the motor .

[Image: P1080391_zpsea83aef1.jpg]


The fan is then mounted .


[Image: P1080393_zpsfcec0b5e.jpg]


Next up the fan case ,  with my design I can have the fan outlet LH ,RH horizontal   or    LH , RH  vertical .

[Image: P1080395_zpsc4945bd2.jpg]


Finally the intake , this still needs some work .

[Image: P1080396_zpsc19153ed.jpg]



So there we go , all done bar the outlet transition piece .


[Image: P1080400_zps6a0285be.jpg]
[Image: P1080402_zps43f2a93c.jpg]



Cheers Rob 
Reply
Thanks given by:
Beautiful work Rob! That should work out real well and look good at the same time.

Ed
Reply
Thanks given by:
might want to take the old finger and give it a couple spins just to see if it stops in the same spot every time.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
well just brill rob will have to cum over to see it run   Thumbsup Thumbsup
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
Quality work Rob Drool Drool  , make sure its unplugged if you stick the old finger in to check  ............. looks like it would be good at chopping fingers off Yikes . Should be up and running soon Big Grin

  Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
Nice work Rob
Hunting American dentists since 2015.
Reply
Thanks given by:
so glad I found this forum.

So very impressed with the workmanship here; mind is full of inspiration. Keep the pictures coming.
Reply
Thanks given by:




Users browsing this thread: 4 Guest(s)