06-18-2014, 08:44 AM
Darren, I am against reposting (quoting) pics from the immediately preceding post. 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
Stuck Revolving Centre in Tailstock Spindle
Stuck Revolving Centre in Tailstock Spindle
|
Stuck Revolving Centre in Tailstock Spindle
|
06-18-2014, 09:05 AM
Oh... you mean the bearings in the live centre. I wasn't hammering on that; only the wedges which are between the joint. Would that have impact on the bearings in the live centre?
Wongster
http://www.wongstersproduction.com Proud to be a member of MetalworkingFun Forum since Mar 2012.
My point exactly, Wong.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
06-18-2014, 04:47 PM
My point too, the wedges don't put a load on the.bearings when the taper's stuck in a mill spindle or similar (drill quill? Lathe spindle?), which is why I made 'em - and they're usually more.effective than a hammer and a drift too :-)
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
06-19-2014, 03:29 AM
had the same type of problem and solved it by using a u bolt and a hammer
tighten the u bolt over the gap until it wont move then bash hard on the bent part of the u bolt out she pops
donny meads, proud to be a member of MetalworkingFun Forum since Jun 2014.
07-01-2014, 07:44 PM
Hi Wongster,
I get the same sticking trouble with the MT taper on my mill all the hammering won't shift the tool,i use a good dose of pipe freeze spray allways works, why not try it. Cheers. Ronnie.
bigman1, proud to be a member of MetalworkingFun Forum since Feb 2014.
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 2 Guest(s)