Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
Man. That's an inspiring thought.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
The following 2 users Like Shawn's post:
EdK (09-26-2014), Mayhem (09-27-2014)
09-26-2014, 08:05 PM
(This post was last modified: 09-26-2014, 08:05 PM by Shawn.)
Pretty happy with the press fit bearing holes I bored today. The axle is a tight sliding fit in both bearings, had to use sandpaper to hit the mark but at least I didn't go past.
![[Image: image.jpg]](http://s28.postimg.org/vlrbs7zpp/image.jpg)
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
Nice work Shawn, very nice
DaveH
