Building John "Doubleboost's" ER-32 collet chuck.
#11
After reading back through this I need to make a correction. I chucked a piece of round cold rolled steel and turned it down to just a bit more than .500" or so, THEN put the .500" ER32 collet on it and set the taper angle.
In other words you want to very slightly expand the collet before you use a dial indicator to set the cross slide angle.
If it's crazy but it works, it's not crazy.
Reply
Thanks given by:
#12
That looks really nice - excellent job. Smiley-signs107 Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#13
Looks very nice
I think you need a new DTI the one in the video must be broken DroolDroolDroolDroolDroolDroolDrool
John
Reply
Thanks given by:
#14
well dun
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#15
You have made a cracking job of that DroolDrool, well done Worthy

Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)