Timber Framing Saw
#31
I know you should see me whack up a car wheel with one.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
#32
Have the posts and top beam finished. The black smith shop kit is starting to look more like a kit, less assembly required.

[Image: IMG_0760.jpg]

Some cleanup needed though.

[Image: IMG_0759.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#33
That is a mess any of us would be proud of.

Nice job on the timbers Greg.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#34
It's really starting to come together Greg. Thumbsup

Ed
Reply
Thanks given by:
#35
You put the bar back on the chainsaw upside down Greg Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
#36
(09-10-2013, 07:24 AM)Mayhem Wrote: You put the bar back on the chainsaw upside down Greg Big Grin

You caught me, I'd cut too far so reversed the bar to fill in the mistake.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#37
Started on the knee braces.

[Image: IMG_0762.jpg]

And they even fit.

[Image: IMG_0764.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#38
Very nice work Greg! Those knee braces look great!
Larry
LJP, proud to be a member of MetalworkingFun Forum since Aug 2013.
Reply
Thanks given by:
#39
Wow, they are good ThumbsupWorthy
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#40
(09-10-2013, 07:24 AM)Mayhem Wrote: You put the bar back on the chainsaw upside down Greg Big Grin

Proper procedure with a chainsaw is to flip the bar each time you change or the remove the blade, for sharpening or to change it, that way you avoid wearing one side of the bar excessively.

Chainsaws with excessive use, that have not had the bar flipped have a concave profile on the bottom of the bar.

then there is the ones that have been modified with a curved section added to the bar so they cut scallops.

Walter
starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.
Reply
Thanks given by:




Users browsing this thread: 15 Guest(s)