09-01-2013, 04:32 PM
well all of them have about 3 to 4 degrees but with them being cut on an angle the ones on the inside don't look like they have very much, but they are also a lot thicker then the ones on the outside that I put in today. the nice looking ones I did today are only 2 inches tall and are about 3/8 inch wide at the web and taper up to about 1/8 at the high point on the hub the other edge is 3/4 inch high.
Damn pulleys gonna make and old man out of me yet, there's too much work to redo it if I screw up
DA
Damn pulleys gonna make and old man out of me yet, there's too much work to redo it if I screw up
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!