Fixing a Leaky RF-45 Mill Head - Enco
(07-03-2012, 11:37 PM)Highpower Wrote:
(07-03-2012, 05:50 PM)EdK Wrote: It appears we have primary fluid retention. Smiley-dancenana

Ed

When did this turn into a shuttle launch? 17428

Rotfl

I live a rather boring (pun intended) life so I had to spice it up a bit. Rolleyes

Ed
Reply
Thanks given by:
(07-03-2012, 11:50 PM)Mayhem Wrote: I thought he was commenting on his ailing health. I was going to suggest diuretics but this would be unwise without a full medical history, blood work up etc!

That comes later in the week. Jawdrop

Ed
Reply
Thanks given by:
Just an update. Still no leaks, but I haven't powered it up yet. I'm working on packaging the VFD and related electronics in a proper enclosure. I just had them bolted to a board on the wall so now is the time to do it properly.

Ed
Reply
Thanks given by:
Ed,
So is the mill all back together now?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
(07-14-2012, 01:18 PM)DaveH Wrote: Ed,
So is the mill all back together now?
Smiley-eatdrink004
DaveH

All except the spindle which is fairly easy to install.

Ed
Reply
Thanks given by:
Some progress on the electrical enclosure.

Ed

   
Reply
Thanks given by:
Looking good Ed. Thumbsup
Willie
Reply
Thanks given by: EdK
keep it up Thumbsup
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by: EdK
(07-17-2012, 06:26 PM)EdK Wrote: Some progress on the electrical enclosure.

Ed

Hey Ed, where do you purchase a box like that?
Collecting tools for 30 years.
Reply
Thanks given by:
(07-18-2012, 12:29 PM)DanH Wrote: Hey Ed, where do you purchase a box like that?

Dan,

I got mine from Menards, a home center based mainly in the north central states. Home Depot also carries them.

http://www.homedepot.com/webapp/wcs/stor...1594559997

Lowes probably also sells them. They're about $35.

Ed
Reply
Thanks given by:




Users browsing this thread: 5 Guest(s)