Fixing a Leaky RF-45 Mill Head - Enco
In order to appease a rather fussy member, I got rid of the invisible paint. Big Grin

Ed

   
Reply
Thanks given by:
Ed,
I can see it now - Thanks Thumbsup
RotflRotflRotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
It appears we have primary fluid retention. Smiley-dancenana

Ed

   
Reply
Thanks given by:
Ed,

That is good news ThumbsupThumbsupThumbsup
Seems you did a good job Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Dave,

Not so quick. Tomorrow morning with tell whether I did a good job, but thanks anyway. Smile

Ed
Reply
Thanks given by:
Looking good so far Ed. Well done. It is always nice to be able to put something back together and not have bits left over. You don't have bits left over do you?

Just kidding!
Hunting American dentists since 2015.
Reply
Thanks given by:
(07-03-2012, 06:52 PM)Mayhem Wrote: Looking good so far Ed. Well done. It is always nice to be able to put something back together and not have bits left over. You don't have bits left over do you?

Just kidding!

Not yet, but then I haven't reassembled the spindle and downfeed mechanism yet so there's still hope, or is that tragedy. 17428

Ed
Reply
Thanks given by:
(07-03-2012, 05:50 PM)EdK Wrote: It appears we have primary fluid retention. Smiley-dancenana

Ed

When did this turn into a shuttle launch? 17428

Rotfl
Willie
Reply
Thanks given by:
(07-03-2012, 11:37 PM)Highpower Wrote:
(07-03-2012, 05:50 PM)EdK Wrote: It appears we have primary fluid retention. Smiley-dancenana

Ed

When did this turn into a shuttle launch? 17428

Rotfl

Shuttle launch? I thought he was commenting on his ailing health. I was going to suggest diuretics but this would be unwise without a full medical history, blood work up etc!
Hunting American dentists since 2015.
Reply
Thanks given by:
well dun ThumbsupThumbsup
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 29 Guest(s)