Cross slide lock with a DRO fitted
#21
(04-05-2013, 06:28 PM)EdK Wrote: . The dimple would move when you adjusted the gibs so it wouldn't make a lot of sense to design one in.

Good question though. I'll check when I take the table apart.

Ed
Didn't think of that Ed, so it's not a "good question" Slaphead
I guess the brass slug is the way to go. 17428
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)