05-24-2013, 04:14 PM
Some real nice work going on hear
All a bit small for my clumsy fingers and weary eyes
John
All a bit small for my clumsy fingers and weary eyes
John
Minimal Clockmaking
|
05-24-2013, 04:14 PM
Some real nice work going on hear
All a bit small for my clumsy fingers and weary eyes John
05-24-2013, 05:56 PM
It's a thing of beauty Brian. I like the look of the cycloidal tooth profile. It's very...clock like.
Tom
05-25-2013, 08:46 AM
Its running on the test stand, with a Foliot from another clock.
It will stay on test to run it in while other parts are made. Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
05-25-2013, 10:48 AM
nice to see it coming together
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
05-29-2013, 01:30 PM
Next job is to get the motion work set up, first the gears are put on the depthing tool, to get them running at the same centres, this measurement will be transferd to the front plate, to place the min wheel stud.
The --minute wheel pipe -- hour wheel pipe --and hour wheel collet all run co axial on the stud. When this is done its on to the dial.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
05-30-2013, 02:39 PM
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
05-31-2013, 12:41 PM
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
05-31-2013, 12:53 PM
Nice work as always Brian.
Ed |
« Next Oldest | Next Newest »
|