Shop Press

[starlight_tools]

(08-24-2013, 11:35 AM)aametalmaster Wrote:

(02-01-2013, 09:12 PM)starlight_tools Wrote: So I am thinking again about getting started on a bender. I like the looks of this one from Iroquios Iron Works


Walter

I like that too. Any updates Walter...Bob

Still on the hunt for 1" thick T-1 plate for the base.

Walter

[DaveH]

I upgraded my press to use the air/hydraulic 20T jack.
The jack is held by a 10mm bolt, the 'top foot' was drilled and taped 10mm.
So you could say it is "hanging by a thread" ................. ........I don't know where I find them
'hanging by a thread'
   

I also made a knob for the release valve - just makes life a little eaier.
   


DaveH

[EdK]

I like the knob you made for the relief valve. I'll need to make one for mine also.

Ed

[ETC57]

Yes Yes a knob is what I need!!
It's amazing how little time saving things such as a knob never seem to make it into my gray matter!