MetalworkingFun Forum › Machining › General Metalworking Discussion v
Cross slide Brg mod & new dial.

Thread Modes
Cross slide Brg mod & new dial.
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#13
08-20-2012, 07:58 PM
Once again nice job Claude. Will give the numbers another try but the skim cut I've needed was deep enough to remove the offending mess.
Thanks
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Cross slide Brg mod & new dial. - by claudef - 08-17-2012, 07:55 PM
RE: Cross slide Brg mod & new dial. - by PixMan - 08-17-2012, 08:01 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-17-2012, 10:59 PM
RE: Cross slide Brg mod & new dial. - by krv3000 - 08-18-2012, 05:56 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 07:02 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 01:44 PM
RE: Cross slide Brg mod & new dial. - by DaveH - 08-18-2012, 02:08 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-18-2012, 02:39 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-18-2012, 04:46 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-19-2012, 02:53 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-20-2012, 04:55 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-20-2012, 07:58 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-21-2012, 01:40 PM
RE: Cross slide Brg mod & new dial. - by EdK - 08-21-2012, 03:33 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-24-2012, 12:00 PM
RE: Cross slide Brg mod & new dial. - by ETC57 - 08-20-2012, 10:00 PM
RE: Cross slide Brg mod & new dial. - by Mayhem - 08-21-2012, 07:26 AM
RE: Cross slide Brg mod & new dial. - by stevec - 08-21-2012, 03:25 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-24-2012, 04:24 PM



Users browsing this thread: 1 Guest(s)