MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tooling-Slitter advice

Thread Modes
Tooling-Slitter advice
wawoodman Offline
Junior
****
Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA
#11
03-02-2017, 08:52 PM (This post was last modified: 03-02-2017, 08:53 PM by wawoodman.)
I didn't know that, Tom. Thanks!

I learn all sorts of things, here!
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
Tooling-Slitter advice - by pepi - 02-28-2017, 07:51 AM
RE: Tooling-Slitter advice - by rleete - 02-28-2017, 09:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-01-2017, 12:34 AM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 06:22 PM
RE: Tooling-Slitter advice - by TomG - 03-01-2017, 07:47 PM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 09:25 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 10:10 AM
RE: Tooling-Slitter advice - by pepi - 03-02-2017, 10:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-02-2017, 02:10 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 06:07 PM
RE: Tooling-Slitter advice - by wawoodman - 03-02-2017, 08:52 PM
RE: Tooling-Slitter advice - by Mayhem - 03-03-2017, 05:22 AM
RE: Tooling-Slitter advice - by pepi - 03-03-2017, 07:38 AM



Users browsing this thread: 1 Guest(s)