The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machining Chamfers

Thread Modes
Machining Chamfers
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#1
10-08-2016, 01:44 PM
This may sound like a dumb question but here goes. When a drawing calls out a chamfer dimension of say .25 x 45 degrees, is that .25" dimension the measurement of the face of the chamfer or some other dimension? 17428

Ed
Reply
Thanks given by:


Messages In This Thread
Machining Chamfers - by EdK - 10-08-2016, 01:44 PM
RE: Machining Chamfers - by RobWilson - 10-08-2016, 01:53 PM
RE: Machining Chamfers - by EdK - 10-08-2016, 03:07 PM
RE: Machining Chamfers - by Mayhem - 10-08-2016, 05:11 PM
RE: Machining Chamfers - by the penguin - 10-08-2016, 05:58 PM
RE: Machining Chamfers - by wawoodman - 10-08-2016, 11:01 PM
RE: Machining Chamfers - by RobWilson - 10-09-2016, 10:24 AM
RE: Machining Chamfers - by RobWilson - 10-09-2016, 10:27 AM



Users browsing this thread: 1 Guest(s)