|
Bending Question
|
09-26-2016, 10:58 PM
(09-26-2016, 08:01 PM)PixMan Wrote: For $1.19 each why are you bothering to try to make them? I doubt I could buy 1080 steel stock for much less than that and there's waste in stamping them out. How will you get the serrations, contoured shape like that and the heat treating done for a price anywhere near that? Amen says the choir. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Bending Question - by Rainman1 - 09-25-2016, 07:05 AM
RE: Bending Question - by pepi - 09-25-2016, 07:28 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:51 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:57 AM
RE: Bending Question - by ieezitin - 09-25-2016, 08:13 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:32 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:34 AM
RE: Bending Question - by dallen - 09-25-2016, 10:13 AM
RE: Bending Question - by ieezitin - 09-25-2016, 07:34 PM
RE: Bending Question - by aametalmaster - 09-25-2016, 08:38 PM
RE: Bending Question - by PixMan - 09-26-2016, 08:01 PM
RE: Bending Question - by Dr Stan - 09-26-2016, 10:58 PM
|
