Okay, Where Is It

Thread Modes

Okay, Where Is It

the penguin Offline

Junior

Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny

The following 2 users Like the penguin's post:
JScott (04-02-2016), arvidj (04-02-2016)

04-02-2016, 10:21 AM (This post was last modified: 04-02-2016, 10:46 AM by the penguin.)

About 6-7 years ago, I got a 24" long certified test bar for checking the lathe, for use with a dial indicator. Huge bucks at the time, Its in a sealed case, I've used it about 3 times, last time was about 2 years ago, now its missing, I looked for about 3 hours yesterday and another 2 hours this morning. Damn!! it hard when you can't remember crap.

jack

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Okay, Where Is It - by the penguin - 04-02-2016, 10:21 AM

RE: Okay, Where Is It - by JScott - 04-02-2016, 10:27 AM

RE: Okay, Where Is It - by Dr Stan - 04-02-2016, 11:57 AM

RE: Okay, Where Is It - by Sunset Machine - 04-02-2016, 12:31 PM

RE: Okay, Where Is It - by hermetic - 04-02-2016, 01:55 PM

RE: Okay, Where Is It - by hermetic - 04-02-2016, 01:57 PM

RE: Okay, Where Is It - by mcostello - 04-02-2016, 02:02 PM

RE: Okay, Where Is It - by f350ca - 04-02-2016, 03:59 PM