+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Okay, Where Is It (/thread-3136.html)
Okay, Where Is It - the penguin - 04-02-2016
About 6-7 years ago, I got a 24" long certified test bar for checking the lathe, for use with a dial indicator. Huge bucks at the time, Its in a sealed case, I've used it about 3 times, last time was about 2 years ago, now its missing, I looked for about 3 hours yesterday and another 2 hours this morning. Damn!! it hard when you can't remember crap.
RE: Okay, Where Is It - JScott - 04-02-2016
Just put one on order and you'll find it 10 minutes later.
RE: Okay, Where Is It - Dr Stan - 04-02-2016
It's right where you left it. Sorry, just couldn't let the easy opportunity pass. :)
RE: Okay, Where Is It - Sunset Machine - 04-02-2016
I always ask my wife where stuff is.
RE: Okay, Where Is It - hermetic - 04-02-2016
you probably found an amazing bit of tough stock you didn't know you had and made something out of it!
RE: Okay, Where Is It - hermetic - 04-02-2016
Alternately, who did you lend it to?
RE: Okay, Where Is It - mcostello - 04-02-2016
It is with the piece of keystock that has disappeared here!
RE: Okay, Where Is It - f350ca - 04-02-2016
Maybe it was beside my carbide tipped scriber that I spent at least a half hour scouring the shop for. Checked the bench, the floor, the bench again, drawers it may have fallen in, the bench again the welding bench, the bench again and finally gave up. Mentioned it to Charlie, he looked on the bench and there it was .
RE: Okay, Where Is It - EdK - 04-02-2016
It's probably right next to the universal protractor I know I bought and Amazon says I bought but I can't seem to find.
Ed
RE: Okay, Where Is It - TomG - 04-02-2016
Horseshoe stake?