MetalworkingFun Forum › Machining › General Metalworking Discussion v
Ball turner tool geometry

Thread Modes
Ball turner tool geometry
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
The following 1 user Likes aametalmaster's post:
EdK (12-05-2015)
#7
12-05-2015, 05:49 PM
Here is something I learned the hard way when turning balls with a shank. Hope tis pic clears what I am trying to say...Bob


Attached Files Thumbnail(s)
   
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Ball turner tool geometry - by ieezitin - 11-09-2015, 07:15 PM
RE: Ball turner tool geometry - by EdK - 11-09-2015, 08:02 PM
RE: Ball turner tool geometry - by DaveH - 11-09-2015, 08:08 PM
RE: Ball turner tool geometry - by ieezitin - 11-09-2015, 08:21 PM
RE: Ball turner tool geometry - by Vinny - 11-09-2015, 08:24 PM
RE: Ball turner tool geometry - by loggerhogger - 11-24-2015, 11:13 PM
RE: Ball turner tool geometry - by aametalmaster - 12-05-2015, 05:49 PM



Users browsing this thread: 1 Guest(s)