08-30-2012, 04:29 PM
(08-30-2012, 12:16 PM)EdK Wrote:(08-30-2012, 09:53 AM)starlight_tools Wrote:(08-29-2012, 07:07 PM)EdK Wrote: I bet Walter could give you a source for the manual. He should respond within a couple of days.
Ed
Ed
You have a copy, I am sure as it is on the Disk I sent you.
Alan
I have a copy of the M2 manual, I will PM you and get your email address so I can send you a copy.
Walter
That would mean I'd have to know where I put the disks. I need to find them and take another look at the contents again anyway. I've hardly stepped foot in the shop all summer other than to make sure the lathe isn't rusting due to lack of use.
Ed
That was a pretty big stack of disks, should not be too hard to find.
Lots of good info on them.
Walter
starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.