MetalworkingFun Forum › Machining › General Metalworking Discussion v
Cross slide Brg mod & new dial.

Thread Modes
Cross slide Brg mod & new dial.
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#19
08-21-2012, 03:33 PM
(08-21-2012, 01:40 PM)claudef Wrote: This is the setup I used for stamping the numbers... hope this helps.
Claude

I'm seeing nutn so nope, no help. Big Grin

Ed
Reply
Thanks given by:


Messages In This Thread
Cross slide Brg mod & new dial. - by claudef - 08-17-2012, 07:55 PM
RE: Cross slide Brg mod & new dial. - by PixMan - 08-17-2012, 08:01 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-17-2012, 10:59 PM
RE: Cross slide Brg mod & new dial. - by krv3000 - 08-18-2012, 05:56 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 07:02 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 01:44 PM
RE: Cross slide Brg mod & new dial. - by DaveH - 08-18-2012, 02:08 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-18-2012, 02:39 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-18-2012, 04:46 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-19-2012, 02:53 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-20-2012, 04:55 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-20-2012, 07:58 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-21-2012, 01:40 PM
RE: Cross slide Brg mod & new dial. - by EdK - 08-21-2012, 03:33 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-24-2012, 12:00 PM
RE: Cross slide Brg mod & new dial. - by ETC57 - 08-20-2012, 10:00 PM
RE: Cross slide Brg mod & new dial. - by Mayhem - 08-21-2012, 07:26 AM
RE: Cross slide Brg mod & new dial. - by stevec - 08-21-2012, 03:25 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-24-2012, 04:24 PM



Users browsing this thread: 2 Guest(s)