MetalworkingFun Forum › Machining › General Metalworking Discussion v
Cross slide Brg mod & new dial.

Thread Modes
Cross slide Brg mod & new dial.
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#9
08-18-2012, 04:46 PM
Very nice Claude. How did you do the numbers? They look far too good to be stamped.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Cross slide Brg mod & new dial. - by claudef - 08-17-2012, 07:55 PM
RE: Cross slide Brg mod & new dial. - by PixMan - 08-17-2012, 08:01 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-17-2012, 10:59 PM
RE: Cross slide Brg mod & new dial. - by krv3000 - 08-18-2012, 05:56 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 07:02 AM
RE: Cross slide Brg mod & new dial. - by claudef - 08-18-2012, 01:44 PM
RE: Cross slide Brg mod & new dial. - by DaveH - 08-18-2012, 02:08 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-18-2012, 02:39 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-18-2012, 04:46 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-19-2012, 02:53 PM
RE: Cross slide Brg mod & new dial. - by TOM REED - 08-20-2012, 04:55 PM
RE: Cross slide Brg mod & new dial. - by f350ca - 08-20-2012, 07:58 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-21-2012, 01:40 PM
RE: Cross slide Brg mod & new dial. - by EdK - 08-21-2012, 03:33 PM
RE: Cross slide Brg mod & new dial. - by claudef - 08-24-2012, 12:00 PM
RE: Cross slide Brg mod & new dial. - by ETC57 - 08-20-2012, 10:00 PM
RE: Cross slide Brg mod & new dial. - by Mayhem - 08-21-2012, 07:26 AM
RE: Cross slide Brg mod & new dial. - by stevec - 08-21-2012, 03:25 PM
RE: Cross slide Brg mod & new dial. - by stevec - 08-24-2012, 04:24 PM



Users browsing this thread: 1 Guest(s)