MetalworkingFun Forum › Machining › Projects v
Big Steam Engine

Thread Modes
Big Steam Engine
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#14
08-06-2012, 02:54 PM
Hi
Nelson
The cylinder mounting pad can be reduced in height as can the cylinder face
Once i get the cylinder cast & machined up i will get a better idea
I was looking at 1/2 inch key steel for the cross head guide
Thanks for your comments
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Big Steam Engine - by doubleboost - 07-22-2012, 04:12 PM
RE: Big Steam Engine - by krv3000 - 07-22-2012, 04:15 PM
RE: Big Steam Engine - by doubleboost - 07-22-2012, 04:19 PM
RE: Big Steam Engine - by DaveH - 07-22-2012, 04:29 PM
RE: Big Steam Engine - by krv3000 - 07-22-2012, 04:38 PM
RE: Big Steam Engine - by Mayhem - 07-23-2012, 05:53 AM
RE: Big Steam Engine - by doubleboost - 07-29-2012, 02:55 PM
RE: Big Steam Engine - by EdK - 07-29-2012, 04:58 PM
RE: Big Steam Engine - by doubleboost - 07-29-2012, 05:08 PM
RE: Big Steam Engine - by DaveH - 07-29-2012, 05:20 PM
RE: Big Steam Engine - by TomG - 07-31-2012, 07:04 AM
RE: Big Steam Engine - by doubleboost - 07-31-2012, 02:47 PM
RE: Big Steam Engine - by nel2lar - 08-05-2012, 06:45 PM
RE: Big Steam Engine - by doubleboost - 08-06-2012, 02:54 PM



Users browsing this thread: 1 Guest(s)