|
Hexy ER 32 Collet Holder
|
03-04-2012, 06:15 PM
(03-04-2012, 06:06 PM)ETC57 Wrote: Nice work John, Hi Jerry So would i  I used my square one to make a chuck key The hex one will be good for one off bolt heads ect Once it is set up in a mill vice you simply turn it over to put flats on to round bar I will post some pictures of it in action John |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Hexy ER 32 Collet Holder - by doubleboost - 03-03-2012, 05:31 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-03-2012, 05:48 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-03-2012, 05:53 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-03-2012, 05:58 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-04-2012, 04:23 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-04-2012, 04:31 PM
RE: Hexy ER 32 Collet Holder - by ETC57 - 03-04-2012, 06:06 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-04-2012, 06:15 PM
RE: Hexy ER 32 Collet Holder - by ETC57 - 03-04-2012, 06:31 PM
RE: Hexy ER 32 Collet Holder - by EdK - 03-04-2012, 07:29 PM
RE: Hexy ER 32 Collet Holder - by miner49r - 03-05-2012, 12:38 AM
RE: Hexy ER 32 Collet Holder - by Mayhem - 06-29-2012, 08:59 PM
RE: Hexy ER 32 Collet Holder - by krv3000 - 06-30-2012, 02:08 PM
RE: Hexy ER 32 Collet Holder - by LIRF - 11-09-2013, 03:45 PM
|
