New Project

Thread Modes

New Project

stevec Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

#10

07-22-2012, 07:31 PM

Don't mean to nag, Tom, but my 6 inch Kurt clone is a good size on my Tree mill but the 4" was a better fit for the mill drill.
Just my take.

Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.

« Next Oldest | Next Newest »

Messages In This Thread

New Project - by TOM REED - 07-21-2012, 10:40 PM

RE: New Project - by EdK - 07-21-2012, 10:52 PM

RE: New Project - by Mayhem - 07-22-2012, 01:39 AM

RE: New Project - by sasquatch - 07-22-2012, 07:51 AM

RE: New Project - by DaveH - 07-22-2012, 07:57 AM

RE: New Project - by Turbinedoctor - 07-22-2012, 08:53 AM

RE: New Project - by ETC57 - 07-22-2012, 09:11 AM

RE: New Project - by stevec - 07-22-2012, 09:29 AM

RE: New Project - by TOM REED - 07-22-2012, 04:24 PM

RE: New Project - by stevec - 07-22-2012, 07:31 PM

RE: New Project - by EdK - 07-23-2012, 05:39 AM

RE: New Project - by stevec - 07-23-2012, 02:29 PM

RE: New Project - by TOM REED - 07-23-2012, 09:54 PM

RE: New Project - by EdK - 07-24-2012, 05:30 AM

RE: New Project - by DaveH - 07-24-2012, 05:59 AM

RE: New Project - by TOM REED - 07-24-2012, 06:10 PM

RE: New Project - by EdK - 07-24-2012, 06:14 PM

RE: New Project - by Tony Wells - 07-24-2012, 06:44 PM

RE: New Project - by stevec - 07-24-2012, 07:28 PM

RE: New Project - by sasquatch - 07-24-2012, 07:36 PM

RE: New Project - by Tony Wells - 07-24-2012, 07:40 PM

RE: New Project - by TOM REED - 07-24-2012, 08:28 PM

Users browsing this thread: 3 Guest(s)