Boring heads for the mill

[DaveH]

(06-22-2012, 03:33 PM)Keith_W Wrote: Hi All,
I am new to this forum and would like to ask if you have had any expriances or knowledge of this Boring Head, Toolmaster VBHU.
I have bought this unit for my Mill but have not used it as yet as am making a few modifications to the Mill Control and fitting a VSD.

Regards,
Keith.

Hi Keith,
Let me just say 'Welcome to MetalworkingFun' and we hope you are enjoying it here

That looks a very nice boring head, nice addition to your workshop

DaveH

[pineyfolks]

A simple bar with a tool that can be slid in and out and set with a micrometer will get you by for one time jobs. Make several, setup on a scrap piece and write the bore sizes on them, put them in your toolbox for next time or change them as needed.