MetalworkingFun Forum › Machining › General Metalworking Discussion v
New Project

Thread Modes
New Project
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#5
07-22-2012, 07:57 AM
Tom,

Good to see you up and on Thumbsup
I have a similar sized mill RF30 the max sized end mill I have used is 3/4" (20mm) I felt at the time it was nearing my machines capability.
I don't like it when my mill rocks n' rolls and has the shudders RotflRotflRotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
New Project - by TOM REED - 07-21-2012, 10:40 PM
RE: New Project - by EdK - 07-21-2012, 10:52 PM
RE: New Project - by Mayhem - 07-22-2012, 01:39 AM
RE: New Project - by sasquatch - 07-22-2012, 07:51 AM
RE: New Project - by DaveH - 07-22-2012, 07:57 AM
RE: New Project - by Turbinedoctor - 07-22-2012, 08:53 AM
RE: New Project - by ETC57 - 07-22-2012, 09:11 AM
RE: New Project - by stevec - 07-22-2012, 09:29 AM
RE: New Project - by TOM REED - 07-22-2012, 04:24 PM
RE: New Project - by stevec - 07-22-2012, 07:31 PM
RE: New Project - by EdK - 07-23-2012, 05:39 AM
RE: New Project - by stevec - 07-23-2012, 02:29 PM
RE: New Project - by TOM REED - 07-23-2012, 09:54 PM
RE: New Project - by EdK - 07-24-2012, 05:30 AM
RE: New Project - by DaveH - 07-24-2012, 05:59 AM
RE: New Project - by TOM REED - 07-24-2012, 06:10 PM
RE: New Project - by EdK - 07-24-2012, 06:14 PM
RE: New Project - by Tony Wells - 07-24-2012, 06:44 PM
RE: New Project - by stevec - 07-24-2012, 07:28 PM
RE: New Project - by sasquatch - 07-24-2012, 07:36 PM
RE: New Project - by Tony Wells - 07-24-2012, 07:40 PM
RE: New Project - by TOM REED - 07-24-2012, 08:28 PM



Users browsing this thread: 3 Guest(s)