cutting gears

[dallen]

(07-16-2012, 10:05 AM)Sunset Machine Wrote: I'd have to check, but I think all of my cutters are #2,#3 and one #4. None of them have dulled from use. The others in a set wouldn't have been used at all.

I have a question about your chart, it says that the number four cutter cuts from 26 to 34 teeth, but the cutter that I ordered is a number 4 and its marked 21 to 25 curious as to which is right or do different makers make the cutters differently.

Anyway here is a photo of the gear that I did get to turn out workable I won't say anywhere near as good as it should be but for a first its passable.

Also made another Arbor this one is for 18MM which is what the shaft size is on my 12 inch lathe.