08-24-2024, 10:42 AM
(08-17-2024, 11:12 AM)rubes Wrote: I have a similar one, with the same goose neck, on my mill. the goose neck is so limp it does not hold position.
Although, now that I think about it, it could be due to the fact I have the base mounted such that the goose neck comes out horizontal. that is the area that will not stay put and sags.
Mine does the same thing. I was just down in the shop, and after trying to adjust it, only to have it slowly droop out of position, I moved it. Now it's at the top of the column on the control box. Unfortunately, the box is plastic, so it won't "stick" with the magnet. My solution was to make a steel plate taped to the box with 3M VHB tape.
I removed the stupid people warning label, don't tell OSHA.
Full of ideas, but slow to produce parts