06-19-2024, 06:51 PM
Okay, so this isn't metalworking, but I whipped it up inside 2.5 hours, and it involved tapping lots of holes. The plastic was salvaged from the scrap bin, and the screws are discards from the electroforming department. Total cost to me was time spent.
I got to move into my huge new office yesterday. Today was spent getting all my stuff put away and setting up the new computer. This new one is a mini tower, and to keep cord clutter to a minimum, I put it under my fancy new desk. But that means I have to reach way underneath to hit the power button or get on my knees. At my age, that doesn't seem like a very good option. So, I built this riser to get the box up off the floor and puts the power button within reach.
I may have gone a bit overboard with the screws, but I didn't want to use any cement, so overkill it is.
I got to move into my huge new office yesterday. Today was spent getting all my stuff put away and setting up the new computer. This new one is a mini tower, and to keep cord clutter to a minimum, I put it under my fancy new desk. But that means I have to reach way underneath to hit the power button or get on my knees. At my age, that doesn't seem like a very good option. So, I built this riser to get the box up off the floor and puts the power button within reach.
I may have gone a bit overboard with the screws, but I didn't want to use any cement, so overkill it is.
Full of ideas, but slow to produce parts