Mill X-axis Powerfeed for G08689

[rleete]

I found a 200 RPM gearmotor at DigiKey, but it only has about 1.5 ft-lbs of torque; I'm not sure that will be enough. The problem arises when you get those small motors that the torque falls off as the speed increases. So, getting decent speeds for a fast return means too little torque at lower speeds such as for milling.

But after searching for several days, I think I have found a solution. It is going to require some creative engineering (Rube Goldberg) to mount, but I think it should work. Pictures to follow as I get parts in hand to test.