MetalworkingFun Forum › Machining › General Metalworking Discussion v
Knackered parting tool holder

Thread Modes
Knackered parting tool holder
rleete Offline
Senior
*****
Posts: 771
Threads: 48
Joined: Mar 2012
Location: Rochester, NY
#4
01-19-2024, 01:26 PM
Tool shank is .395 (10mm) square. Inserts are about .098 or 2.5mm. the blade part that holds the inserts is thinner than that, so it looks like it could hold the thinner ones.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK


Messages In This Thread
Knackered parting tool holder - by Dell - 01-19-2024, 08:55 AM
RE: Knackered parting tool holder - by rleete - 01-19-2024, 10:44 AM
RE: Knackered parting tool holder - by EdK - 01-19-2024, 11:16 AM
RE: Knackered parting tool holder - by rleete - 01-19-2024, 01:26 PM
RE: Knackered parting tool holder - by Highpower - 01-19-2024, 07:26 PM
RE: Knackered parting tool holder - by Vinny - 01-22-2024, 06:58 PM
RE: Knackered parting tool holder - by Dell - 01-23-2024, 09:23 AM
RE: Knackered parting tool holder - by Highpower - 01-23-2024, 10:25 AM
RE: Knackered parting tool holder - by Dell - 01-24-2024, 07:49 AM
RE: Knackered parting tool holder - by Dell - 01-24-2024, 08:54 AM
RE: Knackered parting tool holder - by Dell - 01-26-2024, 08:11 AM
RE: Knackered parting tool holder - by BaronJ - 02-28-2024, 05:44 AM
RE: Knackered parting tool holder - by Highpower - 02-28-2024, 07:09 AM
RE: Knackered parting tool holder - by EdK - 02-28-2024, 11:55 AM
RE: Knackered parting tool holder - by BaronJ - 02-28-2024, 02:21 PM
RE: Knackered parting tool holder - by Highpower - 02-28-2024, 06:50 PM
RE: Knackered parting tool holder - by EdK - 02-29-2024, 02:24 AM
RE: Knackered parting tool holder - by BaronJ - 02-29-2024, 03:33 AM
RE: Knackered parting tool holder - by rleete - 02-28-2024, 01:38 PM



Users browsing this thread: 3 Guest(s)