Latest Delivery

[EdK]

(04-09-2022, 10:18 AM)TomG Wrote:

(04-09-2022, 10:11 AM)EdK Wrote:

(04-09-2022, 10:08 AM)TomG Wrote: Not sure how hard the steel is, but maybe it could be pinned.

Tom

I was thinking of drilling it at the seam and pinning it with a threaded pin so it could be pulled out if needed. Then the two could be separated if needed.

Ed

If you go with a threaded pin, a pipe plug may be in order, so there is no play. They are available down to 1/16" NPT.

Tom

I meant an internal thread in the pin. Smooth outer surface. They call them "Pull-Out Dowel Pins" on McMaster's web site.

Ed