02-16-2022, 11:02 AM
Mine has 4, and it's still not enough!
What I did was make a 1/2" aluminum plate to mount to the top, and now I can drill and tap holes in that where ever needed. The plate has a boss on the bottom that registers into the hole in the center of the rotary table, so I can remove it and return it to the same position.
What I did was make a 1/2" aluminum plate to mount to the top, and now I can drill and tap holes in that where ever needed. The plate has a boss on the bottom that registers into the hole in the center of the rotary table, so I can remove it and return it to the same position.
Full of ideas, but slow to produce parts