|
Powered Drill Press Table
|
01-16-2022, 11:39 PM
Now I finally know what I can do with the actuator I took off an old treadmill. Should be a fun project. I'll set it up so I can swing the table. 4" actuator, so maybe a scissor lift moving a sliding collar.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Powered Drill Press Table - by rleete - 01-16-2022, 02:44 PM
RE: Powered Drill Press Table - by Pete O - 01-16-2022, 04:54 PM
RE: Powered Drill Press Table - by rleete - 01-17-2022, 09:34 AM
RE: Powered Drill Press Table - by Dave J - 01-21-2022, 06:38 AM
RE: Powered Drill Press Table - by Highpower - 01-16-2022, 05:50 PM
RE: Powered Drill Press Table - by Hawkeye - 01-16-2022, 11:39 PM
RE: Powered Drill Press Table - by Highpower - 01-17-2022, 10:07 AM
RE: Powered Drill Press Table - by rleete - 01-21-2022, 08:29 AM
|
