The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Mini lathe surprise

Thread Modes
Mini lathe surprise
nitram55 Offline
Freshman
**
Posts: 1
Threads: 1
Joined: Apr 2020
Location: england
#1
10-15-2021, 01:54 PM
Striping my Mini Lathe down to replace the drive belt, decided to take the headstock off to check the internal gears while I was at it, this is what I found.

If at first you don't succeed just drill it again.


Attached Files Thumbnail(s)
   
Reply
Thanks given by:


Messages In This Thread
Mini lathe surprise - by nitram55 - 10-15-2021, 01:54 PM
RE: Mini lathe surprise - by Highpower - 10-15-2021, 06:10 PM
RE: Mini lathe surprise - by Dr Stan - 10-15-2021, 06:33 PM
RE: Mini lathe surprise - by EdK - 10-16-2021, 10:03 AM



Users browsing this thread: 1 Guest(s)