+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: Mini lathe surprise (/thread-4355.html)
Mini lathe surprise - nitram55 - 10-15-2021
Striping my Mini Lathe down to replace the drive belt, decided to take the headstock off to check the internal gears while I was at it, this is what I found.
If at first you don't succeed just drill it again.
RE: Mini lathe surprise - Highpower - 10-15-2021
All the more reason to tear them down right out of the box and give everything a good cleaning and inspection.
RE: Mini lathe surprise - Dr Stan - 10-15-2021
WOW! They could at least plugged the incorrect holes.
RE: Mini lathe surprise - EdK - 10-16-2021
Yikes!
Ed