New furnace build

[b4dyc]

(07-03-2012, 06:30 PM)dallen Wrote: you may want to think about making that lid a lift an swing affair, so you don't have all the heat that the lid will soak up looking you in the face when you open the lid
DA

This sounds sensible to me, any ideas how I can convert what I have (links to similar?) as this already has a fair bit of time and money thrown at it

(07-03-2012, 04:19 PM)RobWilson Wrote: Hi Andy
Looking good
What you planning on casting?
Rob

I started this project as I was going to make a shaper, but I now have one ( 3 phase, not yet working) but I do want to make some pulleys and would like to build some steam(air) engine parts and this looks a good way to do some of it