02-26-2012, 04:44 PM
Thanks Lads 
i much appreciate your comments and interest .
Darren ,,,,, i remembered correctly 12" x16" ,, the good thing about steel flasks is if i say need a deeper cope or drag ,, i can just tack weld two together
Hi there Jerry ,,,,,,,,,,, i just took my time heating and bending the corners . I was expecting a bit flattering ,, but i got away with it this time .
Hi Ed ,,,,,,,,,,,,,, I am with Tom on this one ,,, it welds just fine , but i would not use it structurally ,,,great for handles , tongs and the likes
Rob
i much appreciate your comments and interest .Darren ,,,,, i remembered correctly 12" x16" ,, the good thing about steel flasks is if i say need a deeper cope or drag ,, i can just tack weld two together
Hi there Jerry ,,,,,,,,,,, i just took my time heating and bending the corners . I was expecting a bit flattering ,, but i got away with it this time .
Hi Ed ,,,,,,,,,,,,,, I am with Tom on this one ,,, it welds just fine , but i would not use it structurally ,,,great for handles , tongs and the likes
Rob