MetalworkingFun Forum › Machining › General Shop Stuff v
Need some ventilation systems advise

Thread Modes
Need some ventilation systems advise
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
Dr Stan (05-05-2020)
#2
05-04-2020, 06:51 PM
If you go with one fan, be sure to put dampers in both ducts, so you can block off the one you aren't using to keep from sucking too much room air outside.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Need some ventilation systems advise - by Dr Stan - 05-04-2020, 11:16 AM
RE: Need some ventilation systems advise - by TomG - 05-04-2020, 06:51 PM



Users browsing this thread: 2 Guest(s)