MetalworkingFun Forum › Machining › Welding & Casting v
New furnace build

Thread Modes
New furnace build
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#8
06-29-2012, 08:53 PM
Some one was killed over here last year cutting the top off of a 44 gallon drum with an angle grinder. If I ever have to cut a container that has held a flammable liquid/gas, I fill it with water first.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
New furnace build - by b4dyc - 06-28-2012, 04:10 PM
RE: New furnace build - by ETC57 - 06-28-2012, 07:41 PM
RE: New furnace build - by Mayhem - 06-28-2012, 08:16 PM
RE: New furnace build - by Bill Gruby - 06-29-2012, 06:55 AM
RE: New furnace build - by Highpower - 06-29-2012, 07:20 AM
RE: New furnace build - by ETC57 - 06-29-2012, 08:35 AM
RE: New furnace build - by Highpower - 06-29-2012, 10:31 AM
RE: New furnace build - by Mayhem - 06-29-2012, 08:53 PM
RE: New furnace build - by b4dyc - 07-03-2012, 04:14 PM
RE: New furnace build - by RobWilson - 07-03-2012, 04:19 PM
RE: New furnace build - by dallen - 07-03-2012, 06:30 PM
RE: New furnace build - by Mayhem - 07-04-2012, 05:34 AM
RE: New furnace build - by RobWilson - 07-04-2012, 05:46 AM
RE: New furnace build - by Mayhem - 07-04-2012, 06:20 AM
RE: New furnace build - by b4dyc - 07-04-2012, 03:02 PM
RE: New furnace build - by ETC57 - 07-08-2012, 10:40 AM



Users browsing this thread: 2 Guest(s)