04-27-2018, 03:46 AM
They were just parallel, I just used the hold down to fix them on the table and worked side milling. I wanted to have 120 mm parallels and I cut 130 mm bars. It turned out that the usable length of my parallels is more 100 mm and they fall in the hall of the vice. So next time I'll cut 160mm to get 120mm, to be on the safe side.
Attached a picture of the other part.
The bumps on the side are because it still does not come natural to get the right direction to turn the dials, I have 50% possibility and I get it wrong sometime.
D.
Attached a picture of the other part.
The bumps on the side are because it still does not come natural to get the right direction to turn the dials, I have 50% possibility and I get it wrong sometime.
D.