I need some help with this repair

Hello There, Guest! Register

Thread Modes

I need some help with this repair

awemawson Offline

Offline

Junior

Posts: 642
Threads: 14
Joined: Oct 2013
Location: East Sussex, UK

#16

10-15-2017, 04:41 AM

Presumably the lifting capacity is directly proportional to the piston area, so if the new piston is 5% larger then so will the lifting capacity

Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

I need some help with this repair - by Pete O - 10-09-2017, 05:28 AM

RE: I need some help with this repair - by TomG - 10-09-2017, 09:07 AM

RE: I need some help with this repair - by Dr Stan - 10-09-2017, 12:07 PM

RE: I need some help with this repair - by f350ca - 10-09-2017, 12:19 PM

RE: I need some help with this repair - by SteveG - 10-09-2017, 08:30 PM

RE: I need some help with this repair - by Pete O - 10-09-2017, 09:41 PM

RE: I need some help with this repair - by TomG - 10-10-2017, 07:01 AM

RE: I need some help with this repair - by f350ca - 10-10-2017, 08:29 AM

RE: I need some help with this repair - by Pete O - 10-10-2017, 04:45 PM

RE: I need some help with this repair - by Pete O - 10-11-2017, 04:38 AM

RE: I need some help with this repair - by Pete O - 10-14-2017, 05:25 AM

RE: I need some help with this repair - by TomG - 10-14-2017, 07:38 AM

RE: I need some help with this repair - by Highpower - 10-14-2017, 12:41 PM

RE: I need some help with this repair - by f350ca - 10-14-2017, 09:08 AM

RE: I need some help with this repair - by Pete O - 10-14-2017, 04:59 PM

RE: I need some help with this repair - by awemawson - 10-15-2017, 04:41 AM

RE: I need some help with this repair - by Pete O - 10-16-2017, 04:01 AM

Users browsing this thread: 1 Guest(s)