MetalworkingFun Forum › Machining › General Metalworking Discussion v
I need some help with this repair

Thread Modes
I need some help with this repair
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#7
10-10-2017, 07:01 AM
Pretty much any steel you choose is going to be adequate for strength, so pick something that machines well. I would go with a free machining leaded steel. "Sissy steel" is I believe how Greg refers to it. Big Grin

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
I need some help with this repair - by Pete O - 10-09-2017, 05:28 AM
RE: I need some help with this repair - by TomG - 10-09-2017, 09:07 AM
RE: I need some help with this repair - by f350ca - 10-09-2017, 12:19 PM
RE: I need some help with this repair - by SteveG - 10-09-2017, 08:30 PM
RE: I need some help with this repair - by Pete O - 10-09-2017, 09:41 PM
RE: I need some help with this repair - by TomG - 10-10-2017, 07:01 AM
RE: I need some help with this repair - by f350ca - 10-10-2017, 08:29 AM
RE: I need some help with this repair - by Pete O - 10-10-2017, 04:45 PM
RE: I need some help with this repair - by Pete O - 10-11-2017, 04:38 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 05:25 AM
RE: I need some help with this repair - by TomG - 10-14-2017, 07:38 AM
RE: I need some help with this repair - by f350ca - 10-14-2017, 09:08 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 04:59 PM
RE: I need some help with this repair - by Pete O - 10-16-2017, 04:01 AM



Users browsing this thread: 2 Guest(s)